[BlondesGift]

Hey Nits! Please try to run your model with the old HecRAS Version 4.1. I tried it and – tadaaaa- the model runs. I can now easily add, extend or interpolate cross sections and the computation runs. With the Version 5.0, 5.02 und 5.03 the problem appears.

I hope this was helpful 🙂

[BlondesGift]

Thank Nits for you post. It is certainly helpful if everyone describes the problem here if it occurs. So maybe we can figure it out…

… now in an other project the problem occurs again. It is a small model with 15 cross sections. Everything was fine till I interpolate new cross sections to integrate bridges. Than the computation stops! I don´t know why and I don´t want to build up the model again…

I would be really, really grateful for any suggestions! It is so frustrating…

[BlondesGift]

First I deleted the Levees. Computation stoped. Then I deleted the Ineffective Flow Areas. Computation still stoped. Then I upload the geometry via CSV and replaced the cross sections. Computation worked…
Thank you for your help!

[BlondesGift]

Hello,

thank you for answering! Yes, it was working. I have extended a cross-section to better represent the foreland. Then it was still running. After changing the levee in a cross-section the computation stops…
The cross-sections are set at a distance of 20 m from each other and do not overlap. Now I have adjusted the length to minimize the difference….but it still stops…

[Author]

Posts