[BenC]

Hi Adolfo

Thank you for your answer. I will try to modify time step again….

[BenC]

Thank you. Yes I did it
This error message “Incomplete data, the following errors were found: Storage Area:”BR1″ – is missing some initial elevations in the steady flow data.”, and the post-process aborts.” is weird beacause I run Unsteady Flow Analysis and the message ask “steady flow data”.

[BenC]

Hi, thank you for your answer even if… it didn’t work…
I added elevation data where your said (steady flow data/options/storage area elevations). I kept values in unsteady flow data/ initial conditions.
I ran unsteady flow analysis and the same message appeared :
“HEC-RAS Error – Incomplete data, the following errors were found:
Storage Area:”BR1” – is missing some initial elevations in the steady flow data.”…

I continue to try other modifications..
Any other idea ?

[BenC]

I work with HEC-RAS 4.1 and I have a problem quite similar with the one you presented here on june :

I’m also running a simple simulation (RAS 4.1.0), a river reach and three storage areas located at the end of a reach. As it didn’t work, I kept only one storage area and still have the same problem as yours : “The simulation runs properly, generates reasonable results (i’ve checked the hydrographs and so on), but at the beginning of the post-process i receive an error message “Incomplete data, the following errors were found: Storage Area:”BR1″ – is missing some initial elevations in the steady flow data.”, and the post-process aborts.”

I read your message sent to HEC and I tried to reduce computation interval but it didn’t work.
Did you receive any answer from HEC ?

Thanks
Benoît

[Author]

Posts