interpolated_cross_section

[netra]

Hei,

I have put two extra cross-section between measured cross-sections in Hec_Ras geometry file. Now i want these two cross-section to behave as measured so that when I will interpolated in the whole reach.But if i have to delete interpolated cross-section, then these two also deleted. but i want them to remain??

thanks
Netra

[Anonymous]

I think you have to delet the * in the riverstation name after the first interpolation.
Now this two new cross are “measured” for hec-ras

[Hydrojock]

Netra,

KTWW is correct, you can make an interpolated cross section into a normal cross section by deleting the asterisk (*) from the end of the river station number. You can do this in the Cross Section Data Editor under Options>Rename River Station…

Note that you can only delete an asterisk within RAS, you can’t add it back. In other words, you can convert an interpolated cross section to a normal one but you can’t reverse the process. That can only be done by editing the river station name in the geometry file with a text editor.

[Anonymous]

Hi,

you can add the asterisk back by COPYING an “.*” in as typing does not work.
I’ve used this trick several times and have not encountered any problems so far…

[Author]

Posts