I can’t see all cross section in lateral structure

[mab aba]

Hi,

I don’t understand why I can’t see all my cross section in the lateral structure editor. Any help?

thank you

[Anonymous]

It should show the vertical lines. It may not show the river station if there isn’t room. Make the editor full screen and/or zoom in.

Actually, it does look like you have more going on. If you try running it and look again is it still like that?

[mab aba]

I have more river stations. So, it should shows more vertical lines. I don’t understand why it doesn’t show more vertical lines.

[mab aba]

I don’t know what’s the black line in the bottom of the figure and why it doesn’t go into the end of my lateral structure.

and why the the model put the river station 4660 in the end of the lateral structure.

any help?

thank you

[Anonymous]

Ok, I think I might know what is going on.

For a lateral structure there is the length of the line you drew on the geometry editor with your mouse pointer. This is the long line.

There is also the weir station-elevation line. This is the short line. Go to the weir editor and make the weir station as long as the mouse line. The lateral structure editor will tell you how long the GIS line is. The weir stationing should be the same length.

[mab aba]

I still have the same problem:

[Author]

Posts