HTab Parameters

[Anonymous]

I’m working on a large unsteady model that I inherited. In looking at the HTab parameters it appeared they were too coarse, and didn’t extend to the top of the some of the cross sections. I’m curious if setting the increment and number of points the same for all the cross sections so that the final point is much higher than the max WSEL will create any problems. It would be much quicker to set these parameters the same for all the x-sections.

Thanks,

Matt

[cameron]

I generally do just this and set them all to the same. There are some cases where I then go back and adjust as needed, but that does not happen very often.

[Anonymous]

Thanks!

[Author]

Posts