Events (mostly) not fired when using HECRAS 5.00 / 5.03 controller

[robhoney]

Hello,

I’ve tried both the HECRAS 5.03 and HECRAS 5.00 version of the controller. The events seem to be slightly different from what is in the book:

ComputeProgressEvent
ComputeMessageEvent
ComputeComplete

I am running this from C# and when I call Compute_CurrentPlan, it all runs through fine, but the ComputeProgressEvent and ComputeComplete events are never fired. Strangely ComputMessageEvent is fired, but only a few times, with only these messages (for example):

Simulation started at: 21Sep2017 11:13:49 AM
Using 64 Bit Computation Engines
PROCESS:RasGeomWriter

Has anyone experienced the same? Any ideas what’s going on?

Thanks,

Rob H

[Katy S]

Hi Rob,

Did you ever figure out this problem? I’m currently having the same issues — I can run any of the functions but can’t seem to get any of the events fired. Specifically, I’m trying to get the ComputeMessageEvent to fire from Matlab.

[Anonymous]

Hi Katy,

I’m afraid not, have you tried it with a newer version, e.g. 5.07? I’ll give that a go when I get chance.

Rob

[Katy S]

Hi Rob,

I haven’t tried it with a newer version. I will admit that my geometry gives me issues when I try to pull it into 5.07 and works fine in 5.03, so I’ve been hesitant to switch versions.

Katy

[Author]

Posts