1D/2D model error

[Nisha]

Hello,
I am getting error ” Error with program: RasUnsteady64.exe Exit Code = -1073741819″ when I simulate my 1D/2D model. I have introduced four lateral structures. I introduced those one by one. for three of those, model simulated without any issue. But once I installed the third one I’m getting this error in the halfway.(I have common cross section which connects 3 CSs as shown in the attached image.)

Any advice to over come this issue?

Thanks & Regards

[cameron]

If you post your model I will try and take a look at what is going on.

[Nisha]

Thanks Cameron. I really couldn’t find the issue. But what I did was remove all the lateral structures and re-applied it. then it worked.

[Author]

Posts